The current newest firmware for the M10+ is v 2.0, the files can be found below.

LOADER v1.8: 

Firmware SJCAM M10+ v2.5

 

Warning: Once the M10+ firmware has been updated to Version 1.5 or higher, you cannot flash the M10+ to lower firmware versions. This firmware is only for units with Versions v1.6 and below. If you revert back to an older firmware version (like v1.3 or v1.4) after v1.6 has been installed, you may brick your unit and camera will no longer be functional. 

 

 

To upgrade the firmware properly, follow the steps carefully:

Step 1: Please check your current firmware version in the camera settings screen. If your current firmware is v1.5 or lower, please follow start with step 2, if your current firmware is v1.5 or newer, please jump to step 3.

Step 2: Installing Loader Software:

a) Make sure to reformat the MicroSD card. Note: reformatting is a Must.

 b) Drag and Drop software “LD96660A.bin” into the root folder of MicroSD card.

c) Insert microSD card into the M10+ unit and power the camera on. Note: makes sure the camera is off when inserting the card. Once the camera is powered on, turn the M10+ off and remove the card.

 Step 3: Installing the firmware:

d) Delete software LD96660A.bin from the MicroSD card. Next, copy v2.0 firmware “SJCAMM10plus.bin” into the root of the microSD. Note: there is no need to root the card again for Step d.

e) Re-insert the MicroSD into the powered off M10+ and power the unit on. It may take 10-15 seconds for the firmware to install. The blue and yellow light will blink until the firmware is installed and then the unit will power on. Check the firmware version to confirm version has successfully been updated then delete file SJCAMM10plus.bin from card otherwise the firmware will re-install upon re-powering the unit on.